Signal Booster III Specific Alarms

A trap is sent whenever the condition changes.  The possible conditions are:

Alarm Sent	What It Means	What to do about it
DAC Overflow	The output level to the booster is too high	Reduce output power.
ADC Overflow	The input level of the booster is too high	Reduce AGC reference level.
Down Converter LO Not Locked	There is an issue with the 10 MHz clock	In the system tab, make sure that the Use External Oscillator is set to correct value.  If using an external oscillator, make sure that it is providing 10MHz.  If not using external oscillator call support
Up Converter LO Not Locked	There is an issue with the 10 MHz clock	In the system tab, make sure that the Use External Oscillator is set to correct value.  If using an external oscillator, make sure that it is providing 10MHz.  If not using external oscillator call support

Signal Booster III General Alarms 

A trap is sent whenever the condition changes.  The possible conditions are:

Condition	What it means	What to do
Normal	Self Explanatory	This is good.
Power Amp Over Current	Self Explanatory	Call support
Power Amp Over Temperature	Self Explanatory	Make sure heat sink is getting airflow.  Call Support
Module Over Current	Self Explanatory	Call Support
Module Over Temperature	Self Explanatory	Make sure heat sink is getting air flow. Call Support
ADC Overflow	Same as ADC Overflow Alarm	Same as the alarm
DAC Overflow	Same as DAC Overflow Alarm	Same as the alarm
LO Not Locked	Combination of Up Converter and Down Converter Not Locked Alarms	Same As the Alarm
Oscillation has Occurred	There could be a lack of Isolation, Bad load on the output of the booster or an internal error	Check Antenna Isolation and Gain setting in booster. Call Support
Input Overload	Internal Error	Call Support
SPI Flash Read ID	Internal Error	Call Support
SPI Flash Read	Internal Error	Call Support
Channel Module Flash Read Error	Internal Error	Call Support
Channel Module Flash Unlock Error	Internal Error	Call Support
Channel Module Flash Erase Error	Internal Error	Call Support
Channel Module Flash Program Error	Internal Error	Call Support
Filter Restore Read Error	Internal Error	Call Support
Filter Restore Init Error	Internal Error	Call Support
Filter Backup Fault	Internal Error	Call Support
Monitor Read Fault	Internal Error	Call Support
Status ADC Control Fault	Internal Error	Call Support
Status ADC Read Fault	Internal Error	Call Support
Over range Setup Fault	Internal Error	Call Support
Over range Control Fault	Internal Error	Call Support
Over range Read Fault	Internal Error	Call Support
Test Signal Off Fault	The test signal was turned off. No issue.	Status Info
Test Signal On Fault	The test signal is on for at least one of the channels or internal error	If not desired turn the test signal off and filter or wait ten minutes and it will turn off itself.
Channel Module Register Write Fault	Internal Error	Call Support