Latch and Lock connector on sensor

Follow

Unfortunately, The Latch and Lock connector is not replaceable. The complexity of the multilayer board and the intensity of installation during the assembly process make the connector difficult to replace. The Bird Service Center, in general, replaces the entire board as a whole, which then requires a new calibration. Thus the sensor will have to come in for a repair and calibration. To do so please fill out an RMA using the link below.

Returned Materials Authorization Form (RMA) | Bird - The RF Experts (birdrf.com)

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.