Resolving Connection Issues Between the 4042 Sensor and 3141 Meter

Issue: There is a connection error that can prevent the 4042 sensor from being detected by the 3141 meter. This issue occurs due to a disagreement between the sensor and the meter on the sensor's order.

Solution: Follow these steps to reset the digital sensors and establish the connection:

1. Connect the Sensor:

   • Plug the 4042 sensor into the 3141 meter.

2. Reset the Digital Sensors:

   • On the 3141 meter, press the MENU button.
   • Use the DOWN button to navigate to Digital Sensor Setup.
   • Press the ENTER button.
   • Again, use the DOWN button to find Reset Digital Sensors.
   • Press ENTER to reset the digital sensors.

3. Back Out to Scanning Screen:

   • After resetting, navigate back to the scanning screen before attempting to re-add your digital sensors.

By following these steps, the 4042 sensor should be detected by the 3141 meter, resolving the connection issue.

If you continue to experience problems, please contact our support team for further assistance.